Trevor
-
Posts
1,152 -
Joined
-
Last visited
-
Days Won
25
Content Type
Profiles
Forums
Events
Posts posted by Trevor
-
-
Hi....welcome to the Club
Here is a selection of relays which you'll need to identify by the pin configuration but used one for my L200 a while ago and worked a treat
Great looking Micra by the way !
-
Hi...welcome to the Club
Quite a rare model now and you can check 'How Many Left' on a search to see how rare it actually is in the UK
Should be able to find bits and pieces on eBay but may have to be from European sellers
-
Worth having the battery changed as it could be getting a bit low
Also, I believe there may be an issue with the microswitches becoming detached from the circuit board inside the fob.
If you take it into a locksmiths that can change the battery they should be able to tell you if this is the case -
It is worth checking the brake lights are working correctly and also check for any water ingress into the ABS unit
Both of these faults come up for that code -
I think if it was a belt it would most definitely squeal on start up
Belt tensioners can also cause this sort of noise but most generally a squealing belt is down to the make (or most importantly where it is made) and doesn't contain much rubber content, more of a synthetic silicon material which will squeal and stretch no matter how much you tighten it over time -
Hi Richf .... welcome to the Club
Hopefully the Serena should serve you as well as the Bongo did.
Was it corrosion that forced you to part with the Bongo?
-
Hi....welcome to the Club
I would be tempted to look at the gearbox end of the cables as there may be an obstruction between the selector mechanism or even a cable fault.
Otherwise I do know that the plastic cup that the gear lever sits in does wear and sometimes break up so if there is a lot of upward movement in the lever then this may be the casePlease let us know what you find to be the cause
Good to have you onboard!
-
Should pull out or retained by a screw possibly - can you post a photo of the switch
-
Left some info in your other post, you could try SatNav Disks - there are a few companies on the net
-
Not sure of the age of your Micra but also is that an immobiliser key showing in the photo (yellow item)?
-
You could try a Samco hose or similar, far better than original and also probably not too far off the cost of an original item
https://www.demon-tweeks.com/uk/search/shop-by/q/samco hoses
-
Hi keithtoon ....welcome to the Club
There are aftermarket companies on the internet selling SatNav update discs but beware, some work and some don't !
They are not too expensive and worth a try as cheaper than main dealer
-
1
-
-
Hi Claudio.....welcome to the Club
-
power loss
in Topics
Has the problem been resolved yet?
-
Crikey I am surprised about a loose battery terminal in this day and age, used to be a very common problem many years ago on older cars and batteries but don't tend to hear about that much nowadays unless someone just didn't tighten it properly.
The mirror fault sounds like reverse polarity on the motor or switch possibly (a small DC motor can run either way if polarity is reversed)
-
If its a 501 bulb then it just pulls straight out
-
I would start by checking the front tyre pressures are as they should be (see below)
I wonder if they are under-inflated?
-
Hi NeilMc good to have you onboard!
-
Let us know how you get on with it
-
Tang02. Thanks for the detailed and concise method of resolving this issue,
I' m sure other members have (or will) experience this problem at some point-
1
-
-
sounds like the connector rod or cable is broken and would require the dash stripping out to investigate
-
1
-
-
-
Hi....welcome to the Club
Sounds like the mirror programming could be out which would also affect the lane departure
I would definitely go back to the dealers and insist they re-programme the mirror/lane departure calibration settings
Let us know how you get on with it all
-
I guess you can print out the relevant sections or pages to have to hand when under the bonnet
Startup Noise
in Topics
Posted
That sounds like the starter motor
Probably go on forever but have heard this sound many times before and sounds like the pinion gear is dry and slow in returning when the engine starts